HVAC Repair in Parma, OH

Heating and cooling repair in Parma: the blower, ducts, controls and drains your furnace and AC share.

Call (440) 568-9484
Opened basement ceiling showing an insulated supply duct, copper water lines and wiring running between the wooden joists above a block wall

HVAC Repair in Parma: Heating and Cooling as One System

In most houses around Parma the furnace and the central air share one blower, one set of ducts, one filter and one thermostat. The coil for the air conditioner sits on top of the furnace, and the condensate from both drains to the same floor drain or pump. That is why one failed part can stop heat in January and cooling in July. HVAC repair is the work on those shared parts:

  • Blower motors, capacitors and blower wheels that run both the heat and the air conditioning
  • Thermostats, thermostat wire and the low-voltage transformer that powers the controls
  • Duct problems: disconnected runs, crushed flex duct, closed dampers, rooms that never heat or cool
  • Return air paths too small for the furnace, which cause overheating and noise
  • Condensate drains, traps and pumps shared by a 90 percent furnace and the AC coil
  • Humidifiers, media filters and filter racks that let dust bypass the filter

Airflow Problems in Older Parma Ductwork

Fan control board and wiring inside an electric air handler

Ducts in a 1950s house were sized for the furnace that came with it, and that furnace often had no air conditioning at all. Central air added later has to push cooler, heavier air through the same trunk lines. A clogged filter, a dirty coil or a weak blower makes that worse, and the symptoms show up as rooms that never cool, a coil that ices over, or a furnace that trips its limit switch. Clearing the restriction usually fixes both seasons at once.

Apartments, Condos and Townhomes Near Parma

About 36 percent of homes in Parma Heights are in buildings with five or more units (apartments and condos in Parma Heights), and Middleburg Heights has the highest share of townhomes around Parma. Those systems are packed into closets and small utility rooms: a gas or electric furnace with the coil on top, a water heater beside it, and a condenser on a shared pad or a roof. Tight closets run hot, filters get skipped, and the blower and control board take the strain. HVAC repair in these units is mostly about access, airflow and controls.

A Year-Round HVAC Season in Cuyahoga County

NOAA's monthly normals for Cleveland Hopkins put most of the heating load from October through April and most of the cooling load in June, July and August (Cleveland's heating and cooling seasons). Spring and fall bring switchover failures: a system that heated fine all winter but blows warm air on the first 80 degree day, or a furnace that will not light the first cold morning in October after sitting all summer. Both are usually a control, a capacitor or an igniter rather than a failed unit.

HVAC Repair for Parma and Cleveland's South Side

We repair heating and cooling systems in Parma, Parma Heights, Middleburg Heights, Brooklyn and the other suburbs south of Cleveland on the Parma service area list. Specific repairs have their own pages: furnace repair, heating repair and AC repair in Parma.

HVAC Repair Questions

What is the most expensive part of HVAC?

The compressor in the outdoor unit and the heat exchanger in the furnace. When either one fails on an older system, it is often the point where replacing makes more sense than repairing. Most other parts, such as motors, capacitors, igniters, switches and boards, are replaced on their own.

How to tell if your HVAC is going bad?

Rooms that heat or cool unevenly, longer run times, new noises, the system starting and stopping often, ice on the copper lines, water around the furnace, and the same part failing more than once.

How often does an HVAC system need to be serviced?

Twice a year: the heating side before winter and the cooling side before summer. Filters need changing more often than that, especially through a long heating season.

How to properly size HVAC ductwork?

Duct sizing starts from a room-by-room heat loss and heat gain calculation and the airflow each room needs. Undersized returns are the most common mistake and cause noise, short cycling and frozen coils. Houses that added central air to ducts built for heat only often need return work.

Do I need to replace my furnace if I also replace my air conditioner?

Not always. The indoor coil sits on top of the furnace and has to match the new condenser, and the furnace blower has to move the airflow the new AC needs. If the furnace is in good shape and its blower fits the new system, it can stay.

What do they do for HVAC maintenance?

On the heating side: clean the burners and flame sensor, check the igniter, inducer and safety switches, and clear the condensate trap on a high efficiency furnace. On the cooling side: clean the condenser coil, test the capacitor and contactor, and clear the condensate drain. On both: check the blower, the filter and the airflow.

When to call HVAC repair?

When there is no heat or no cooling, a breaker keeps tripping, water shows up at the furnace or the indoor coil, ice forms on the lines, the furnace light is flashing a fault code, or there is a burning smell from the blower.
Other Services and Areas
Heating or Cooling Not Right?

Call (440) 568-9484 for furnace, heating and AC repair.

Call (440) 568-9484