Emergency Furnace Repair in Parma, OH

Emergency furnace repair in Parma and nearby suburbs for no heat, lockouts and furnaces that quit in a cold snap.

Call (440) 568-9484
Blue pilot flame seen through the small sight window of a gas heating unit in a dark room

Emergency Furnace Repair in Parma, Ohio

Furnaces around Cleveland rarely quit on a mild afternoon. They quit on the coldest night of the week, after running almost nonstop for hours, when a worn part finally gives out. Emergency furnace repair is the same work as any furnace repair.

Common furnace failures in a cold snap:

  • The furnace runs but blows cold air, or the burners light and shut off after a few seconds
  • The inducer motor starts, but the burners never light
  • Nothing happens at all when the thermostat calls for heat
  • The furnace is locked out after a pressure switch or limit fault
  • A loud bang, squeal or grinding from the blower or the inducer
  • A boiler that stopped circulating, with the radiators going cold

Emergency Furnace Repair on Cleveland's Coldest Nights

Metal flue pipe venting a vapor plume above a snow-covered roof with long icicles hanging from the gutter

Cleveland Hopkins averages about 37 days a year when the high never gets above freezing, and about 12 nights at 10 degrees or below. Cleveland's all-time record low is minus 20, set on January 19, 1994 (Cleveland's all-time record low). On nights like those a furnace runs almost nonstop. That is when a cracked igniter, a weak inducer bearing or a dirty flame sensor stops the heat. The National Weather Service Cleveland office posts cold-wave and wind chill warnings ahead of time; a furnace that has been short cycling or making noise should be looked at before one of those nights.

Overnight Snow and Blocked Furnace Vents

Overnight lake-effect snow bands can drop several inches by morning. Wind drifts that snow against the side of the house and over the two white PVC pipes a 90 percent furnace uses for intake and exhaust. When a pipe closes, the pressure switch shuts the furnace down and it locks out. A frozen condensate drain line does the same thing. These lockouts are common after a heavy snow and are repaired at the vent or the drain, not by replacing the furnace.

Emergency Furnace Repair in Parma for No Heat

Emergency furnace repair covers Parma, Parma Heights, Seven Hills, North Royalton, Brooklyn, Middleburg Heights and Old Brooklyn. The houses differ: 1950s basement furnaces in north Parma, closet furnaces in Parma Heights apartments, 90 percent furnaces with PVC venting in North Royalton. The full list of parts and symptoms is on the furnace repair page, with boilers and heat pumps on the heating repair page. The rest of the emergency furnace repair service area is listed on the service area page.

No-Heat Problems in Single-Digit Cold

When the outside temperature is in the single digits, pipes in an outside wall or an unheated crawl space are at risk. Cleveland's worst winter storm on record, the Great Blizzard of 1978, showed how fast a house loses heat when the wind is up. If the furnace is out and the house is dropping, call (440) 568-9484.

Emergency Furnace Questions

Why is my furnace blower suddenly so loud?

A squeal points to a worn belt on an older belt-drive blower or dry motor bearings. A rattle or banging usually means a loose or broken blower wheel, or a wheel caked with dirt and out of balance. A loud hum with little air often means a failing run capacitor or a motor about to seize. Grinding means the bearings are worn out.

Why won't my furnace start?

Check that the thermostat is calling for heat and the furnace switch and breaker are on. Past that, the common causes are a cracked igniter, a dirty flame sensor, a pressure switch held open by a blocked vent or a full condensate trap, a blown low-voltage fuse on the control board, or a failed inducer motor.

Is furnace short cycling an emergency?

It becomes one when the house cannot hold its temperature on a cold night. On a cold night the usual culprits are an overheating furnace shutting itself off, a flame sensor too dirty to prove the flame, or ice in a vent pipe or condensate line.

Why would the furnace not work for a few hours then come back on again?

Many control boards lock out after failed starts and reset themselves after about an hour. Ice in the PVC intake or exhaust during wind-driven snow, a condensate line that freezes and thaws, or a limit switch that trips on overheating and resets can all cause the same on-and-off pattern.

What can cause a furnace to stop working?

A flame sensor, igniter, pressure switch, inducer motor, control board, blower motor, a blown low-voltage fuse, or a clogged condensate trap on a high efficiency furnace.

Why is my furnace shutting off repeatedly?

Overheating from a dirty filter or closed registers, a dirty flame sensor, a failing pressure switch, a blocked vent pipe, or a furnace too big for the house.
Other Services and Areas
No Heat? Call Now

Call (440) 568-9484 for furnace, heating and AC repair.

Call (440) 568-9484